SPS | Controller Faulty | Knowledge Base

Controller Faulty
Controller Check
If the DG doesn't start in manual mode and the LLOP is found ok. The next step is to check if the controller is working fine. For this we'll first put the SPS in the manual mode and push the DG start button. Now, we'll check output DC 12 V in ...

Popular Articles
Batter alarm issue battery not
Battery Alarm Issue/ Battery does not charge Check the alarm status and press the reset button. Reset button shown on below image After reset alarm cleared close the call If alarm still exists Check the alarm status by alarm table Check the Battery ...
Fault Tree of DG not Stop in Manual Mode
DG does not stop in manual mode Check DG physically. Check the DG stop solenoid valve, DG Panel and DG battery If found Yes, If DG status is faulty then inform customer that issue is from his end. DG fault not in Delta Scope. If found No, keep SPS on ...
RECIFIER PAHASE ASSIGNMENT IN SMPS/ BSNL SMPS
FOR RECTIFIER PHASE ASSIGNMENT DO THE FOLLOWING STEPS. In main menu go in the Rectifier Option In Rectifier option go in AC measurement option Rectifier > AC Measurement In AC Measurement, Select the line assign L1, L2, L3 which you want (L1= R ...
Battery Module Discharge Issue
.
Voltmeter Card RS485 communication error
Voltmeter Card RS485 communication error can be because of two reasons: First, Loose cable or connector loose and second, module is faulty Cable, connector or module whatever is faulty, replace that.

Controller Faulty